| CREATE A NEW
PROJECT |
 |
1. Enter in
the Project menu> New
2.
In the New Project window set 800x600 pixel
resolution, click on “Load Image” and select in
C:/Programs/3DGeniuX/Tutorials/005/
office.bmp
3. Click
on “Create”
NOTE: Lessons are located in the main folder
where 3D GeniuX is installed, usually in
C:/Programs/3DGeniuX/Tutorials
| |
| LOAD A 3D OBJECT |
1. Enter the Project
menu>Import>File X and select in
C:/Programs/3DGeniuX/Tutorials/005/Office_lamp.x
Click on
"Open |
|
|
2. Select “Visualize only selected part” to
maintain visible on the screen only the sub-object
“Lamp_06” |
|
|
3. Vary the RYB values as shown in
the picture. |
 |
4. Select the sub-object Lamp_05 and change
the RYB values as shown in the picture, and change the
material to “Metal”
|
 |
5. Disable “Visualize only selected part”,
in this way the whole object will be
visible.
|
 |
6. Use the Move tool  to put
the lamp on the desk as shown. |
| |
|
 |
7. Select from the Modify menu>Copy,
then Modify> Paste. You have now created a copy of the
object that is exactly over the original one.
From the
Object Position rollout  invert the values Scale Y%=565.560 to Scale
Y%=-565.560
In
this way, the copy of the object will be seen as a
reflection.
| |
| DRAW MASK |
 |
 |
1. From
tools bar click on enable mask
and select Brush 
2. From
“Mask” rollout set dimension and transparency of the brush as
shown in the picture, and start stroking at the base of the
lamp, to cancel partially the copied object as to make it
appear as a reflection on the desk
surface. |
|
